1stgen Camaro Restorations
1st Generation F-Body Restorations
Ground up Camaro Restorations
Home Page
1968 Camaro
1968 Firebird Ram Air II
1971 Chevelle
Site Map
Cars & Parts for Sale:
1968 Camaro Coupe
Rolling Shells for Sale
Parts for Sale
Camaro Information:
Underbody Specs
Power Top Bleed
Paint Codes
Completed Restorations:
1967 Camaro Convertible
Contact:
E-mail 1stgencamaro.net
Specializing in '67 Camaro
Under Body Specs 67 thru 69 Camaro and Firebird Unibody Dimensions.
These measurements are modified from Fisher Body Specs, to correct printed errors in the Fisher Body manual. All measurements are center to center unless otherwise noted. Car must be setup on a level surface, for accurate measurements. A Tram Gauge is recommended for accurate results. Factory Tolerance plus or minus 1/8 inch. Note: Your car may measure out differently. This is due to difference in measuring methods used. Most important is that the car is square and level to its self. Be sure to read the Notes
Horizontal Dimensions:
Vertical Dimensions:
- A = 38 1/4"
- B = 35 1/4"
- C = 54 3/16"
- D = 44 9/16"
- E = 33 3/4"
- F = 76"
- G = 65 1/4"
- H = 33 1/2"
- I = 55 3/16"
- J = 66 11/16"
- K = 43 7/8"
- L = 44 7/8"
- a = 11 15/16"
- b = 12 9/16"
- c = 13 13/16"
- d = 9 1/8"
- e = 6 15/16"
- f = 18 7/16"
- g = 15 11/16"
Measurement Notes:
- Center of Master Gauge hole outboard of firewall body mount
- Center rear sub-frame to body mount hole
- Center at rear edge of 1" gauge hole
- Center of Master Gauge hole in bottom of frame rail
- Inboard edge of frame rail, at centerline of rear shackle bolt hole (Figure 2)
- Centerline of lower outboard bumper bolt holes
- Location f: Lower surface of rail at axle housing centerline
- Location g: Inboard edge of frame rail, at centerline of rear shackle bolt hole (Figure 2)
©Copyright 2004 - 2008 1stgencamaro.net All rights reserved
Camaro® is a Registered Trade Mark of General Motors Inc All rights reserved